BSNJY - 82C26 NSL

  • MSDS: BSNJY
  • Manufacturer: ENGINEERED FABRICS CORP
  • Product Name: 82C26 NSL
  • National Stock Number: 8040-01-243-6624
Product Identification

Product ID:82C26 NSL
MSDS Date:09/01/1988
FSC:8040
NIIN:01-243-6624
Kit Part:Y
MSDS Number: BSNJY

Responsible Party
ENGINEERED FABRICS CORP
669 GOODYEAR ST
ROCKMART, GA 30153
US

Emergency Phone: 216-379-8562

Info Phone: 404-684-7855

Preparer: MARK S HROSS

Cage: 0KDP8

Contractor
ENGINEERED FABRICS CORPORATION
548 ROCKMART, GA 30153 US

Telephone: 706-684-7855

Cage: 56221

Ingredients

2-BUTANONE (METHYL ETHYL KETONE) (MEK)

CAS: 78-93-3

RTECS: EL6475000

Fraction By Weight: 50-55%

OSHA PEL 200 PPM

ACGIH TLV: 590 MG/CUM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


4,4,'-DIAMINODIPHENYLMETHANE, 4,4-METHYLENE DIANILINE

CAS: 101-77-9

RTECS: BY5425000

Fraction By Weight: 45-50%

ACGIH TLV: 0.81 MG/CUM(SKIN) A2

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: SEVERE IRRITATION. INHALATION:
RESPIRATORY IRRITATION; ANOXIA MAY BE FATAL. SKIN: MODERATE
IRRITATION, DERMATITIS, ALLERGIC SENSITIZATION.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:EYES: REDNESS, TEARING, BLURRED VISION.
INHALATION: FEVER, CHILLS, ANOREXIA, NAUSEA, CYANOSIS. SKIN:
DEFATTING.

First Aid

First Aid:INHALATION: REMOVE TO FRESH AIR. GIVE CPR/OXYGEN AS NEEDED.
EYES: FLUSH W/WATER. SKIN: REMOVE EXCESS MATERIAL. WASH W/SOAP &
WATER. FLUSH W/PLENTY OF WATER. DON'T USE SOLVENTS AS THIS WILL
ENHANCE SKI N ABSORPTION. INGESTION: OBTAIN MEDICALATTENTION IN ALL
CASES.

Fire Fighting

Flash Point Method:CC
Flash Point:16F
Lower Limits:1.4%
Upper Limits:11.4%
Extinguishing Media:ALCOHOL FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:WEAR SELF-CONTAINED BREATHING APPARATUS W/FULL
FACEPIECE UNDER POSITIVE PRESSURE.
Unusual Fire/Explosion Hazard:VAPORS ARE >AIR & MAY TRAVEL ALONG GROUND
OR BE MOVED BY VENTILATION & BE IGNITED AT LOCATIONS DISTANT FROM
MATERIAL HANDLING POINT.

Accidental Release

Spill Release Procedures:REMOVE ALL IGNITION SOURCES. VENTILATE. WEAR
PROTECTIVE EQUIPMENT. DIKE/CONTAIN W/ABSORBANT MATERIALS. DON'T
ALLOW TO DISCHARGE INTO STORM/SANITARY SEWER. PUMP/BAIL MATERIAL
BACK INTO ORIGINAL CONTAIN ER OR CLEAN, EMPTY DOT CONTAINER.

Handling

Handling and Storage Precautions:THE STORAGE AREA SHOULD BE WELL
VENTILATED. STORE AWAY FROM SOURCES HEAT & OPEN FLAME. KEEP
CONTAINER CLOSED WHEN NOT IN USE.
Other Precautions:DON'T WEAR CONTACT LENSES.

Exposure Controls

Respiratory Protection:USE NIOSH/MSHA APPROVED RESPIRATOR; EITHER AN
ATMOSPHERE-SUPPLYING RESPIRATOR OR AIR-PURIFYING RESPIRATOR FOR
ORGANIC VAPORS
Ventilation:ADEQUATE EXPLOSION-PROOF TO MAINTAIN VAPORS BELOW TLV
Protective Gloves:CHEMICAL GOGGLES
Eye Protection:BUTYL
Other Protective Equipment:IMPERVIOUS PROTECTIVE CLOTHING
Supplemental Safety and Health

Chemical Properties

Spec Gravity:0.939
Appearance and Odor:BEIGE LIQUID W/KETONE ODOR
Percent Volatiles by Volume:58

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HEAT & OPEN FLAME
Hazardous Decomposition Products:CO, CO2, NITROGEN OXIDES

Disposal

Waste Disposal Methods:ALL MATERIALS THAT WERE USED IN CLEAN-UP PROCESS
ARE CONSIDERED TO BE HAZARDOUS WASTE. INCINERATE AT A FACILITY
LICENSED FOR DISPOSAL OF IGNITABLE HAZARDOUS WASTE. FLAMMABLE
LIQUID. NA 1133.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.